Since I got a number of the new hard plastic weapon sprues in my recent Bones 3 Kickstarter shipment, I was eager to play with some of them and do some simple conversions on a couple of the new figures.
As shown in my previous post I got two types of weapons sprues from the KS; a grey plastic set that came with the Core set, and a clear plastic set that was a additionally purchased add-on set. Each of these sets came with four different sprues: The Arsenal, The Armory of Virtue, The Armory of Vice, and the Armory of Death.
|All four clear sets.|
|A section of the Armory of Virtue.|
I began by selecting three figures that I thought would be simple ones to do conversions on; with weapon wielding hands accessibly placed on outstretched arms: Galadanoth, Elf Sniper, from the original Core Set, one of the Bandits from the Stoneskull set, and Jurden, Half-Orc Paladin from the Heroes I Set. I also selected three weapons, a clear bow from the Arsenal Set, a hammer from the Armory of Death set, and a sword from the Armory of Virtue.
I began by slicing off the existing weapons directly above and below the hand, trying to leave nice flat cuts perpendicular to the alignment of the hand. I then drilled small holes through the hands with my Dremel tool.
|You can see here I slipped on the archer’s hand and accidentally drilled through part of it.|
Then I used a hobby knife to make a small slice through the hand right at the end of the fingertips and base of the thumb. You need to be extra careful to only cut though one side of the drilled hole, and not slice the whole end of the hand off.
I then test fit the weapons into the hands to make sure the hand would close again around the grip of the weapon. If they were too big, rather than risk drilling a larger hole, I simply filed down the handle of the weapon a little to make its diameter smaller.
I then super glued the weapon into place, and held the hand closed until the glue set. For the archer with the missing section of hand, I tried to apply some extra superglue to fill in where the missing fingers would be. I’ll then attempt to hide the mistake with paint.
via All Bones About It http://allbonesabout.blogspot.com/2017/06/some-quick-and-simple-bones-3-weapon.html
from Tumblr http://tumblr.hawks-club.org/post/161851392183